How do I Enable/Disable 2-Factor Authentication?

1. Log into your Set Power Free account and view your Dashboard. At the bottom left corner of the page, click on your name/email on the account to access your profile details.

2. Below your Name, you should see 4 tabs. Click “Two-Factor Authentication”.

3. To Enable the Two-Factor Authentication, you will need an authenticator app.

   Note: With an authenticator app you should receive a passcode to verify your identity every time you log into your account. The instructions for setup may slightly vary depending on the app used. 

    

   1. Enter your Set Power Free Account Password and Click Continue.

   2. A QR code, or an address to copy, will be supplied to add to your authenticator app. Once added to your authenticator app, a code should be available to input into the 2FA fields to verify.

      i. Keep in mind, there may be a countdown, in the app, that will refresh and provide a new code. Try to verify the code before it refreshes or wait for the next code.

   3. Once the correct code is fully entered, it should be verified and you should receive indication that your Two-Factor Authentication was successfully enabled. Then Click Done.

Instructions on how to Deactivate (Disable) 2 Factor Authentication:

6. To Disable the Two-Factor Authentication, you will go to your profile settings and go to 2 Factor Authentication, same as when you start to set up 2FA.

1. Select the current Authentication method that is running (Enabled) and Click Disable.
2. Click Disable, again, to confirm that you would like to disable your 2 Factor Authentication
   Input an Authentication code, from your activated verification method, into the fields.
3. Once the code is verified, you should be informed that your 2 Factor Authentication was successfully disabled. Then Click Done.